Recently, the sanitation department of Jiangdu District of Yangzhou installed a GPS monitoring system for 12 sets of slag removal tractors. It is reported that the implementation of digital management is an important part of creating innovation, green, and happy sanitation, and is the direction of the development of the sanitation department. After environmental sanitation vehicle to install the system, managers can understand and monitor the situation in real-time position working sanitation vehicles and equipment, job status and other aspects of work efficiency. If the vehicle does not follow the route or there is an abnormal fuel consumption, the system will automatically alarm, the management personnel can promptly notify the relevant driver to correct.
Plate and gasket are the critical part of a removable Plate Heat Exchanger. The main function of the plate is to isolate the medium and perform heat exchange. Its main materials are stainless steel (304/304L, 316/316L, 254SMO), titanium, nickel, titanium-palladium alloy, Hastelloy, etc. The sealing gasket is installed in the gasket groove around the plates to seal the periphery between the plates to prevent the fluid from leaking out, and according to the design requirements, seal part of the corner holes so that the hot and cold media flow according to their own flow paths. The structure of the plate heat exchanger consists of a fixed frame, a movable frame and corrugated plates sandwiched between the two frames. Hot and cold liquids pass sequentially through the area between the corrugated plates separated by sealed elastomer paths. To prevent leaks, good gasket elastomers are installed around the perimeter of the plates and large fastening bolts are used to hold the plates together. The structure of the plate heat exchanger makes sealing a key part of this equipment, responsible for the service life of the entire equipment. Depending on the process medium, the gasket must be chemically and/or temperature resistant. Spetech supplies seals for most existing plate heat exchangers: power industry, petroleum processing, food and beverage industry, sugar industry, chemical, pulp and paper industry. The most commonly used materials are: NBR, HNBR, EPDM, FPM (different grades). There are two basic ideas for the installation of seals: glue seals and clip seals. Clip-on washers do not require any adhesives for installation. This modification makes it possible to mount the spacers by installing clips in the grooves in the plate. As a result, the gasket is highly resistant to pressure and can be replaced quickly and easily.
Heat Exchanger Plate&Gasket,Phe Gasket,Gea Gasket,Nbr Gasket Guangdong Jiema Energy Saving Technology Co.,Ltd , https://www.jiemaheatexchanger.com