How to install axial-flow pump vertical motor, the use must be strictly in accordance with the requirements of the outline drawings and instructions, so that the manufacturer's contract warrant only effective. 1. The motor must be transported when the motor is placed vertically, put the law is: the motor flange down, prohibit the motor flat transport. Motor at the factory after the test paste the certification in the packaging and shipping, in the box with There are random documents, if found after the arrival of the box obvious signs of damage to the sales service department and asked to send a representative to participate in the common open-box inspection, if the motor is found to be unexpected damage should contact with the transport department, at the same time Installation must be further checked. 2. It is forbidden to lift the entire motor without lugs. Welding lugs are attached to the motor housing, through which the entire motor can be lifted. 3. If the motor can not be installed in a timely manner, the motor should be stored, (1) Put the law is: flange down, it is prohibited to lay the motor flat. (2) The motor should be placed in a dry and clean warehouse, prohibit the suspension of dust and other solid particles in the ambient air, acid or alkali and salt spray and other corrosive gases, prohibit the temperature is too high or too low, because the temperature is too large or Dramatic changes, etc., will be very adverse to the preservation of the motor. (3) cover the motor with a waterproof canvas to prevent dust from entering, do not use long-term plastic motor cover motor. If the motor has a heater, to prevent condensation and inhalation of moisture, the heater can be energized. (4) When the inventory time is too long, the insulation resistance should be measured regularly. Storage minimum temperature 5 ° C. 4 pre-installation work procedures. The installation of the motor is carried out according to strict procedures because the performance of the motor depends largely on its adjustment and on the stability of the base. Therefore, the following points must be checked before installation of the motor in case it is put into operation error occured: (1) appearance and mechanical inspection, if the motor has any damage and doubt should report immediately. (2) to determine the center of the foundation in order to establish the center line of the unit and the surface elevation of the foundation. 5. The motor should be placed in compliance with the relevant standards, the following points should be given consideration in place. (1) Except for special requirements when ordering, generally the ambient temperature shall not exceed 40 ° C and the altitude shall not exceed 1000m. (2) Make sure that there is enough working space around the motor for easy disassembly and maintenance. Artificial Turf Machine & Tools Artificial Turf Machine & Tools is used to construct and maintance artificial turf. Artificial Turf Machine & Tools,Sand Brushing Machine,Artificial Grass Brushing Machine,Artificial Turf Sand Filling Machine WUXI DEIICHEN MACHINERY PTY.,LTD , https://www.medicineprocessing.com
ã€Print】 ã€Close】